Torque values are not interchangeable
Rated, repeated peak, start-stop, and emergency limits represent different duty conditions. Confirm your motion profile against the source definition.
PREVIEW / NOT FOR MANUFACTURE
Nidec Drives and Controls · FLEXWAVE WPG
WPG-80-160-CR
Gearhead harmonic reducer configuration with a 160:1 reduction ratio and vendor-specific / unresolved.
Gearheadconfigurationeligiblereviewed
This record is a source-backed research sample, not yet a verified orderable SKU.
Normalized data
Specifications
Performance
Reduction ratio160 :1
Rated torqueNot reported for this source termNot published
Nominal Output TorqueAt 2,000 rpm input178 Nm
Repeated peak torqueNot published
Peak torque at start/stopNot published
Maximum average load torqueNot published
Maximum momentary torqueNot published
Instantaneous torqueNot published
Emergency-stop torqueNot published
Maximum allowable peak torqueNot published
Maximum input speed — source generic4,800 rpm
Maximum input speed — greaseNot published
Maximum input speed — oilNot published
Average input speed limit — greaseNot published
Average input speed limit — oilNot published
Rated / nominal input speed3,000 rpm
Integration
Product formGearhead
Vendor form labelGearhead type with motor-dependent mount code
Input configurationVendor-specific / unresolved
Frame sizeVendor code · explanation only in v0.180
MassNot published
Input moment of inertiaNot published
Rated service life10000 h
All source-labelled observations
Sizesource specific.frame size · explanation only80
Ratio Rreduction ratio · filter-eligible160
Nominal Output Torquenominal output torque at input speed · filter-eligible178 Nm
Maximum Output Torquesource specific.maximum output torque nm · explanation only484 Nm
Nominal Input Speednominal input speed · filter-eligible3000 rpm
Maximum Input Speedmaximum input speed.unspecified lubricant · filter-eligible4800 rpm
Lifesource specific.life h · explanation only10000 h
Engineering context
Selection notes
Form changes integration scope
A component set and an assembled unit with the same ratio may have different mass, bearings, interfaces, and allowable external loads.